Installation
Since this case includes an AiO cooler we will need to prep our motherboard for this cooler. Our build is an Intel build so this prep should be the same for all modern Intel sockets. You’ll need to install the Intel backplate on the backside of your motherboard and then secure it with the Intel spacing screws.
Now install your motherboard in the case and secure it with the included screws. From here you’ll want to connect the included extension cables to your 24-pin ATX and 8-pin EPS connectors. These are individually sleeved and easy to connect.
Before you mount the pump block onto your CPU you’ll need to install the thermal paste. Cooler Master has implemented this system where there is a sticker on the block with holes in it. You apply your thermal paste, spread it, and then remove the sticker. You are left with the proper amount of thermal paste in the correct location on the block. It is worth noting there was not a thermal paste spreading tool included. With our thermal paste installed successfully we install the block on our CPU using the included screws to secure it.
We will be installing our SSD next. I opted to use one of the mounts on the backside of the motherboard tray. Cooler Master uses little pegs that you screw into the bottom of your SSD and then you install rubber grommets on the holes in the mounts. Finally you just place the hard drive into the mount.
The last thing we needed to install was our graphics card, which went in without any issues. For those wondering this case will support graphics cards up to 380mm, that is with the radiator installed in the front of the case.
Finally we just wire everything up and clean up our cables. Again, I was a bit disappointed to not see any velcro straps on the backside of the case. I did use a handful of the included zip ties though. With everything installed we have a very clean build.
